rear brakes for 63 customj 880

[danny <dannymercer5992@xxxxxxxxx>]

        good morning, i would some some ideas or solutions to my
following problem. my rear brakes and drums locked up tight from
sitting way too long.i was able to pry them apart but lost the
passenger side drum in the process. the drivers side is probably
rusted beyond repair. so i am looking at a complete rebuild,drum to
wheel cylinder on both sides. i think the drums are the small bolt
pattern. if i change the whole rear to a slightly newer style my
driveshaft with its funky u bolts <pinion style> will not work. the
newer driveshaft will not fit my pushbutton tranny. i am wrong in any
of these thoughts? i have to keep this on a bargain basement budget as
times are tough and i might need to sell this car. i love this car but
dont have the bottomless pockets i need.    thanks

-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.