|
MO,,,,,, sounds like you have the ones where the connector protrudes above
the floor in the rear foot area, I have not seen a set of instructions, but have
seen the finished product,,, it appears that to install you hold the connector
in place and mark the floor for the cut, you end up with a slit in your rear
pans just a little wider than the connector itself,,,, you then weld the
connector on both ends, and along the slit in pan as well, makes a very solid
piece when finished,,,,
In a message dated 1/8/2012 10:41:02 P.M. Central Standard Time,
micher@xxxxxxxxxxxxxxx writes:
-- Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. |
Back to the Home of the Forward Look Network