${top_text_ad} Hi mike Thanks for the details, again an awesome running machine. One of the 64s I have is a 426 4 spd wedge car from the factory and I'm debating whether to put a 426 wedge block that's been bored .100 (440 .030 over pistons) for originality or take a 440 and stroke it. I'm concerned about the amount of overbore on the orig 426 block (overheat not strong enough etc). Anybody out there have suggestions. I haven't bought the 426 short block yet, but it has the right casting numbers and date code for the car. Anyone have experience with the 426 wedge blocks being bored out that much? Ron -----Original Message----- From: mike creglow [mailto:mcreglow@xxxxxxxxx] Sent: Tuesday, May 25, 2010 10:25 AM To: 1962to1965mopars@xxxxxxxxxx Subject: Re: test and tune ${top_text_ad} hi ron, Drive train: Motor: 400 block with 4.15" Eagle crank, Eagle 440 connecting rods, Ross forged pistons (12.5 compression), gap-less rings, Cam Motion custom grind mech flat tappet cam (.640" lift/ 283 duration @ 50), Indy SR heads that have been ported to max wedge size (valves 2.19/1.81), Indy single plane intake, Holley dominator (8896), MSD ignition system w/ digital 6-plus, crank triggered ignition, TTI 2"/2 1/8" step headers. Transmission: A-727 w/ Griner reverse pattern valve body, Ultimate (A Lopo understudy) 5100 stall converter, bolt in sprag, stock gear set, ultra-bell. mike On Mon, May 24, 2010 at 4:05 PM, Ron Soldani <ronsold102@xxxxxxxxxxxxx> wrote: > > OHHHH YEAHHH awesome Mike. Could you let me know some engine details? I > just gotta 64 Fury that was a drag racer and I need to put a fresh motor in > it. I'd be kool if I could get some runs like that. Thx Ron ${bottom_text_ad} ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. ${bottom_text_ad} ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. This email was sent to: ${recipient} u/?bUrDWg.${encoded_sub_id}.${EMC}