Re: Ball & trunion boot replaced !!

["Gary H." <spigot2039@xxxxxxxxxxx>]

Was it a new reproduction boot?

Below are some links to driveshaft loops that may help you figure out a suitable solution.

http://proaluminumproducts.com/cart/index.php?main_page=product_info&products_id=13

http://www.uscartool.com/loop/mopar.html

http://www.bluecollarperformance.com/mdl1700.html  (66 up B?)

http://www.jegs.com/pt/Drive+Shaft+Loop

http://board.moparts.org/ubbthreads/showflat.php?Cat=0&Number=4782422&Main=4780709


Thanks,
Gary H. 


-----Original Message-----
 
>Thanks to Joe Suchy I now have a brand new boot on my driveshaft. It 
>really wasn't difficult at all. Another step closer to being ready for 
>the races. I want to clean the grease from under the car and also try to 
>install a driveshaft safety loop. My exhaust is soo close it's difficult 
>to find a place to put it.
>
>Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
>
> 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.