Looking to buy some good parts that are missing or damaged - for my ’64 Dodge B body model 440 2 door HT. I thought I might start my search here. Right side Model 440 front outer fender with minimal rust and preferably fully stripped - less inner slash shields, outer moldings etc. Right side Model 440 door shell with minimal rust and preferably fully stripped. And for the above door - RS door latch/lock mechanism along with the linkage piece from the latch ball - end to outer door handle ball - end. (From my LS door, it measures 9 ¼” long 1/2” wide x 1/8” thickness. I have the ball-end connection clips from R/T Specialties.) The heater box (non/AC) under the dash (model 731 is printed on it) is missing a (butterfly?) door located at the bottom outlet. I would expect it to measure something like 14” long x 2 ½” wide and have a round ¼” rod attached to the center axis length-wise for pivoting open/close. I can pick-up if just a couple hours of drive time from the Allentown PA area. Thanks for reading and any help, Dave Bailey _________________________________________________________________ Hotmail has tools for the New Busy. Search, chat and e-mail from your inbox. http://www.windowslive.com/campaign/thenewbusy?ocid=PID27925::T:WLMTAGL:ON:WL:en-US:WM_HMP:032010_1 -- [Non-text portions of this message have been removed] ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. This email was sent to: arc.6265@xxxxxxxxxxxxxx u/?bUrDWg.bSONJP.YXJjLjYy ?p=TEXFOOTER