Don't still have those Traction Masters lying around, do you Rich?? SC -----Original Message----- From: Rich Kinsley [mailto:rlkinsley@xxxxxxxxx] Sent: Friday, February 05, 2010 8:43 PM To: 1962to1965mopars@xxxxxxxxxx Subject: Re: Clutches and parts I was just looking at some old receipts from '64. My custom built clutch by my Uncle at Friction Materials in Long Beach, CA cost me a whole $18.71 for clutch and pressure plate. Hiway robbery :-) I also see where Hayden Proffit Assoc in Garden Grove charged me $10 to weld on my Traction Masters. That'd about be the tax nowadays! Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.