Re: Remote Door Mirror Removal Tips?

[swirldesign@xxxxxxxxxxx]

The hole under the original mirror on my Fury was large enough to pull the lever assemble with the four cables through without disconnecting them. 

----- Original Message ----- 
From: "Gary H." <spigot2039@xxxxxxxxxxx> 
To: 1962to1965mopars@xxxxxxxxxx 
Sent: Friday, September 11, 2009 4:19:45 PM GMT -08:00 US/Canada Pacific 
Subject: Remote Door Mirror Removal Tips? 


Hi all, 

Seems I vaguely recall (been a while) that in the past I've used a screwdriver and carefully pried open the tabs that hold each cable in place just enough to get the cable out. The reverse with a pair of small pliers to install. 
See http://1962to1965mopar.ornocar.com/temp/remote-mirror-cable.jpg for the area I'm writing about. 

The tabs holding the cables don't seem too sturdy, for more than one R&R without snapping off. 

Is there another way to get the mirror off the door? 

Thanks, 
Gary H. 


[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.