Good progress

[Rich Kinsley <rlkinsley@xxxxxxxxx>]

Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies

I have been able to hit it hard the last couple days. My wiring is done 
up to the engine compartment. Actually all I have left is the headlights 
and horn. Then some finishing touches to dress it up. 

I had to make a few mods to the battery box and a little metal 
adjustment to the frame to get the new aluminum radiator to fit. Now I 
need to get the bottom hose neck repositioned just like Dodger had to 
do. I have to figure out a mounting system too. I'm going to bypass the 
rad trans cooler at this time to see how it works without it. If I don't 
like it I can always reroute the lines to the rad too.

Since I might want the steering column back in the car, I still need to 
repair the steering coupler. I couldn't find the right repair kit but I 
think with parts from the wrong kit and a little imagination I can get 
it to work. What kinda lube goes in the coupler? I'm planning on putting 
a little wheel bearing or white grease in there. I can't see how it 
needs much or it might interfere with movement.

Maybe with luck it'll be ready by next week-end :-)


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.