Re: 2 Steps Forward & 3 Steps Back

[chymar01@xxxxxxxxxxx]

No. By swapping the spindles from side to side, the bleeders stay at the top. 

----- Original Message ----- 
From: "Bill" <Y1TopBanana73@xxxxxxxxx> 
To: 1962to1965mopars@xxxxxxxxxx 
Sent: Saturday, April 18, 2009 4:06:09 PM GMT -05:00 US/Canada Eastern 
Subject: Re: 2 Steps Forward & 3 Steps Back 


Greg, doesn't that put the bleeder on the bottom of the caliper? 

Bill 

On Sat, Apr 18, 2009 at 10:13 AM, Greg Parsons <63.sport.fury@xxxxxxxxx> wrote: 
> Bill, 
> 
> If it is the slider type, do what I did to make the hose on the top, move 
> the caliper to the other side, then it is on top! Simple but it works. 
> 
> Greg 


---- 
Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 

'62 to '65 Mopar Clubhouse Discussion Guidelines: 
http://www.1962to1965mopar.ornocar.org/mletiq.html. 


[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.