RE: Aluminum vs. cast iron
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Aluminum vs. cast iron



I had a 440 in my 1964 Fury with new, Schumacher mounts.  I used an 
Edelbrock Performer intake and a Thermoquad carb.  With a Mr. Gasket 
chrome air cleaner and a short air filter, the wingnut tore through the 
hood insulation pad.



Douglas J wrote:
> 
> 
> Which brings up a point I was pondering.  Is there a hood clearance or 
> linkage problem with Performer or the older Torkers ect type intakes? I 
> don't recall problems with RB engines years ago, but I ran smaller 
> aircleaners on those.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 












Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.