Wire harness update/opinion

[Rich Kinsley <rlkinsley@xxxxxxxxx>]

Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies

I thought I'd just give some insight as to the Ron Francis wire harness 
set-up. The materials and components are very good quality and well 
thought out. The issue is that it's really not Mopar specific or even 
primarily so. It requires lot's of reference to the FSM wiring diagrams 
and plenty of modification. I don't mind because I'm not worried about 
original. I do believe it will be a better system when I am done. Being 
a retired electrician I can read the wire diagrams and figure things 
out. I'd be hesitant to attack this project without some reasonable 
knowledge. Stock would be easier as you can just follow what was done 
previously. I just thought a little heads up for you guys might help 
someone stay out of trouble. I'm going real slow and careful and solving 
other problems along the way too. I'm making an "as built" diagram also 
to make future mods and trouble shooting easier.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.