Re: Valve cover hardware

[george smith <bt6t4@xxxxxxxxx>]

I believe they did.At the bottom corners.Some even had
studs in all six holes.
--- Mike Phelps <mikeph@xxxxxxxxxxxxx> wrote:

> 
>   A quick question. I am trying to go back to as
> close to stock 
> appearing as I can on my 361 and to that end I found
> some stock valve 
> covers to replace the aftermarket chrome ones that
> were on it. However, 
> I don't have the correct bolts. I've seen the bolt
> sets at a few of the 
> vendors but my question is did the 65-361 valve
> covers have two locating 
> studs per cover as the sets provide or all bolts?
> Any advise would be 
> appreciated. 
> 
> 
> 
> Mike Phelps
> 1965 Plymouth Belvedere II Convertible
> 361/727
> 2004 Hemi Ram Quad Cab
> 2004 Chrysler 300M 3.5HO
> 2004 PT Cruiser 2.4 Turbo
> 
> 
> ----
> Please address private mail -- mail of interest to
> only one person -- directly to that person.  I.e.,
> send parts/car transactions and negotiations as well
> as other personal messages only to the intended
> recipient, not to the Clubhouse public address. This
> practice will protect your privacy, reduce the total
> volume of mail and fine tune the content signal to
> Mopar topic.  Thanks!
> 
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html. 
>
> 
> 


George



      


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.