Valve cover hardware

[Mike Phelps <mikeph@xxxxxxxxxxxxx>]

  A quick question. I am trying to go back to as close to stock 
appearing as I can on my 361 and to that end I found some stock valve 
covers to replace the aftermarket chrome ones that were on it. However, 
I don't have the correct bolts. I've seen the bolt sets at a few of the 
vendors but my question is did the 65-361 valve covers have two locating 
studs per cover as the sets provide or all bolts? Any advise would be 
appreciated. 



Mike Phelps
1965 Plymouth Belvedere II Convertible
361/727
2004 Hemi Ram Quad Cab
2004 Chrysler 300M 3.5HO
2004 PT Cruiser 2.4 Turbo


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.