${top_text_ad} 1 Change fluids before start up. 2 Remove spark plugs & liberly apply Marvel Mystery Oil to cylenders. 3 Let soak for a while 4 crank engine over by hand a few times. 5 install spark plugs, perform tune up 6 Start her up. If I missed anything, someone else will chime in. Good luck with the car. Before driving on the street, rebuild brakes completely. Rebuild carb, have a water pump nearby. The alternater may crap out also. Have fun!!!!!!! Bob K ----- Original Message ---- From: neal zimmerman <neal.zimmerman@xxxxxxxxx> To: 1962to1965mopars <1962to1965mopars@xxxxxxxxxx> Sent: Saturday, May 17, 2008 7:02:08 PM Subject: waking up a sleeping 318 Off topic again , sorry. Engine in my cuda is 318 LA and 904 auto. The car has been in storage 20 years. the motor was last ran about 5 years ago. The engine was in great shape when they stored the car so i know its not broken and was stored with cooling system drained so a busted block from freezing isnt an issue. I am definitely removing fuel tank and having it dunked, and flushing the fuel lines . questions and concerns such as:1) priming oil pump? 2) new fluids first or fire on old fluids,then change fluids? 3) engine cleaning treatments, trans fix treatments,? 4)etc, etc. i Just dont want to destroy a motor that might get me down the road until winter when i can build a righteous small block for it. Neal zimmmerman, eugene oregon ${bottom_text_ad} ---- Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! '62 to '65 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html. This email was sent to: ${recipient} u/?bUrDWg.${encoded_sub_id}.${EMC}