frame connector install
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

frame connector install




I understand to put the car weight on the wheels when installing frame  
connectors, including putting the drivers weight in the seat, but how about the  
welding?  I have the Mopar connectors which are bolt in.  I was going  to bolt 
them in and then weld around where they connect to the subframes.   Some 
recommend welding them to the floor.  Is this a common practice?   Should it be 
welded full length or just stiched along the way?  Mopar says  they're not needed 
in a automatic car, but I have them and I figure they can't  hurt.  Any 
suggestions on the welding?  Thanks -  Joe

[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

http:///u/?.. 
Or send an email to: 1962to1965mopars-unsubscribe@


http:///?p=





Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.