Bill and all, There was a revision to Pat Blais' Ebay address -- or the tech Chebby hackers got into it or the vendor's page! <grin> The information on the 62-65 Vendor's page is old. I will update that 62-65 page tonight. Here is the working address for his Ebay store: https://www.ebay.com/str/tflitepattysshopmart And here is one way to reach him, I assume. https://www.ebay.com/str/tflitepattysshopmart#tab1 Thanks, Gary H. > -------Original Message------- > > > Neal, et-al., I used the link for Pat Blais' ebay page on the vendor's > page, but eBay says the page is missing. Also, sent email, but it > "wasn't delivered to TFLITEPATTY@xxxxxxxxxxx because the address > couldn't be found, or is unable to receive mail". > > On Tue, May 31, 2022 at 10:26 PM neal zimmerman > wrote: > > > Yes, Pat Blais is still in business. Just talked to him a few weeks > > ago. His ebay stall is called Tflite Patty. He prefers emails over > > phone calls > > Neal Z > > > > On Tue, May 31, 2022 at 6:51 PM <62-65-mail-list-club@xxxxxxxxxxx> > > wrote: > > > >> Here is one speedo gear chart: > >> > >> > > > https://1962to1965mopar.ornocar.com/images/1962-1965-speedometer-pinion-gear-chart.jpg > >> > >> You can ask Joe Suchy about the O-ring and seal and also Pat > >> Blais Transmissions in Marysville, WA > >> but I'm not sure if Pat is still in business. Their contact info > >> is on > >> https://1962to1965mopar.ornocar.com/restoration-sources.html > >> > >> Was the speedometer needle bouncing a bit when you heard the > >> clicking noise? > >> > >> Thanks, > >> Gary H. > >> > >>> -------Original Message------- > >>> > >>> > >>> Yes, that end of the cable seems ok. I pulled it out and lubed > >> it when > >>> it began clicking and the needle was erratic. The cable looked > >> fine > >>> and it seemed to be working right for a while, maybe about 100 > >> miles, > >>> then began clicking again and stopped working completely. > >>> > >>> On Tue, May 31, 2022 at 7:42 AM 'Doug' via The 1962 to 1965 > >> Mopar Mail > >>> List Clubhouse < > wrote: > >>> > >>>> did you check the dash ?may have fallen out > >>>> > >>>> On Monday, May 30, 2022, 10:48:08 PM EDT, Bill Stevson > >>>> wrote: > >>>> > >>>> Greetings from the Ozarks, needing some advice here. I am > >>>> thinking/hoping the pinion gear in my 1965 727 Torqueflite is > >> why my > >>>> speedometer stopped working. Since I changed rear tire size > >> was > >>>> planning to replace it anyway. The chart I saw says I need a > >> 32 > >>>> teeth gear for 27" tall tires. Can someone verify this for > >> me? > >>>> Suggestions where to buy a kit with O-ring and seal? Any tips > >> on > >>>> following Service manual instruction to "carefully work the > >> pinion > >>>> and sleeve assembly out of the housing"? > >>>> Bill Stevson > >>>> 1965 Plymouth Satellite > >>>> > >>> -- -- -- Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. --- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@xxxxxxxxxxxxxxxx. To view this discussion on the web visit https://groups.google.com/d/msgid/1962to1965mopars/20220601223458.32348.qmail%40server309.com.