Re: Poly Header performance question

[RCoronetfreak@xxxxxxx]

===========================================================
Your opinion counts! We?re conducting a survey for a 
computer service/repair company. When you complete our 
survey, you will also be entered into a drawing for one of 
ten $100 prizes. Just click
caab6Pib7yoMza/ Val Rad
===========================================================

I think when it comes right down to it, the Weiand intake is purchased 
because the factory single four unit is like hens teeth.  I lucked out, my Coronets 
poly was from a '62 Fury so it had the original intake and the intake on my 
Fury was in the back of my '65 Belvedere parts car along with other poly parts.  
I have seen poly single four intakes but they are usually expensive.  It is a 
shame that someone didn't make a better intake for a poly motor.  I know my 
biggest complaint with the Weiand was the poor casting quality.  I couldn't put 
a socket on some of the intake bolts and I had to grind off the back to get 
it to clear the distributor.  
Rick 

[Non-text portions of this message have been removed]

===========================================================
$6.95 .com Domain Name Sale! 
Limited Time! ICANN Accredited GoDaddy! 
caab7pQb7yoMzf/ GoDaddy
===========================================================

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



b7yoMz.