Re: {Chrysler 300} Chrysler 300 Convertible Top Maintenance

I can't imagine anything "clogged". Was the fluid level low? If you filled it you may have air in the system. If I recall the level should be checked when the top is open, not closed. Does it have more or less trouble when the engine is running? Have you checked the ground connection at the motor? Disconnect and clean all the electrical connections at the switch and the motor itself. Remove the metal contacts from the plastic connectors and clean them by blasting, with a wire brush, or Deoxit solution. Lubricate all the pivot points in the top. If all else fails it may be time to replace the pump and/or cylinders .

Mike Laiserin

On Sunday, December 15, 2024 at 09:01:20 AM MST, <mplindahl@xxxxxxxxxxxxx> wrote:

Hello All,

My convertible top lifts up just fine when the top is up and it has to move off the windshield to lower it. It has a lot of problems lifting from the open position (resting in front of the trunk).

I tried cycling it, but each time the top is open, it struggles to lift up the first half of the cycle. I have not checked to see if the hose/cylinder is clogged. Is it best to start with the top of the cylinder or bottom? Any other suggestions.

Thank you,

Mark Lindahl

’63 300 Conv.

PS-my pump is using brake fluid, not power steering fluid.

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/023f01db4f0a%248f9c3d10%24aed4b730%24%40sbcglobal.net.