{Chrysler 300} window run channel , hopefully final . A solution

[John Grady <jkg@xxxxxxxxxxxxxxxxx>]

this is what the OEM stuff was like , U unfolded ,  removed from another old one .
That  stitched on felt strip down the back is felt for rubbing . We replaced that with thin Teflon industrial tape.tight on the metal bottom . This will gain about 3/32  to 1/8” — i think room to adjust it 
Note how thin the side strips are — very small both in width and height compared to a fully lined U channel with cat whisker type design , we guess only 1/16” thick (!!) 
And this is fairly flat nap felt , not pile type top  . The hole is where a rivet was . we think glued in to metal U then factory riveted through to outer metal U , no space at all . 
Ron W ‘s Velcro suggestion   is really good , the felt packed with velcro is very like this stuff !we  did this , with the velcro felt glued in to side walls this AM , 
reassembling with confidence ! 

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/4624A375-4F22-41BA-A0F8-D0DACBE4C3AF%40gradyresearch.com.

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/4624A375-4F22-41BA-A0F8-D0DACBE4C3AF%40gradyresearch.com.