I see in the ’62 FSM that the switch and wire covers are the same. http://www.jholst.net/62-service-manual/electrical.pdf Page 75
Rich B.
From: Rich Barber <c300@xxxxxxx>
Sent: Monday, July 15, 2024 11:47 PM
To: 'Matt Allyn' <allynentertainment@xxxxxxxxx>
Subject: RE: {Chrysler 300} 1962 Wiper Switch
On a similar ’64 Chrysler, that spade should have a wire V6, a Dark Blue wire connected to it. That wire feeds power to the park connection on the wiper motor. Nearby should be wire V3, a black wire with white tracer that feeds the wiper motor armature. These two wires are attached to a male two-wire connector which then plugs into a female two wire connector and wires emanating from the wiper motor. Wire colors there should match.
Rich Barber
CA.
Sounds dumb, I know….
Should EVERY spade on the back of the switch have a wire plugged onto it?
I have a bare spade and a rogue wire under the dash.
I think the wire is Black or Dark Blue.
Here’s a picture of the switch (mostly) hooked up.
--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/C515B7FB-6547-49B7-8B9A-F42EBF78FB5B%40yahoo.com.
