{Chrysler 300} Axle - backing plate nuts

["'James Douglas' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

The axle backing plate uses what appear to be tall center nylocks. The old school version where there is a little hole inside a square stamped into the nut and a nylon insert is pressed in. It grabs in the middle of the nut not the end.

 

It is tall like a “heavy nut” but not the next size up wrench wise. So it is not a “true” heavy hex nut.

 

Anyone know if anybody is making these?

 

I can reuse the old ones, or I can just use some heavy hex modern stainless nylocks if they will fit.

 

Thanks, James

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB617156BCE72E28C29DADC46893402%40CY5PR19MB6171.namprd19.prod.outlook.com.