RE: {Chrysler 300} NAPA voltage regulator

I just saw these circuit boards on eBay and purchased them.

James

From: Dave Dumais <dave.dumais@xxxxxxxxx>
Sent: Thursday, March 16, 2023 19:47
To: James Douglas <jdd@xxxxxxxxxx>
Subject: Re: {Chrysler 300} NAPA voltage regulator

Hello James,

May I ask where you sourced the new circuit boards from?

I have a similar ghost with high beam and indicator light.

I used the best of many boards from my stash of used gage clusters, chased wires etc.

No luck.

Thanks,

Dave D

Sent from Yahoo Mail on Android

On Thu, Mar 16, 2023 at 9:30 PM, 'James Douglas' via Chrysler 300 Club International

<chrysler-300-club-international@xxxxxxxxxxxxxxxx> wrote:

Hi All,

Am I just the lucky one or has anyone else had an issue with over voltage with a new NAPA voltage regulator?

I picked up one of those little devices that plug into the cigar lighter and has two US charging ports. It also has a LED read out of the voltage. At first, I though the thing was junk and pulled out my Fluke Tester and sure enough the voltage is running between 14 and 16 volts. A little too high.

I may just spend the money and get a Transpro V1200 regulator. That way I can set the output voltage.

James

PS to Bob et.al, The new manufacture circuit boards for the cluster did the trick and the ghosting of the high beam on right turn signal went away with the new boards in. Also, the dash lights are much brighter. Thanks….

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB617116B8EFABCF33810B5AAF93BD9%40CY5PR19MB6171.namprd19.prod.outlook.com.