{Chrysler 300} 1964 Package Tray

["'James Douglas' via Chrysler 300 Club International" <chrysler-300-club-international@xxxxxxxxxxxxxxxx>]

Hi All,

 

At some point in the near future, I will have to pull the package tray to cut it for the rear defroster.

 

It also has a slight sag in the area near the passenger side.

 

This stuff is a pressed particle board. I know from experience that getting it out without it coming out in parts is not fun.

 

Assuming I get it out relatively clean, what methods have people used to rebuild them?

 

My initial thought is to steam the deformed area and see if I can get it back into shape. Then perhaps fiberglass the rear to stiffen it up. Cut the hole for the defroster and then paint the entire unit.

 

Thoughts? Experiences?

 

Thanks, James

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB61716AE85D90F2FBC77DF51393DF9%40CY5PR19MB6171.namprd19.prod.outlook.com.

Attachment: IMG_5298.JPG
Description: IMG_5298.JPG

Attachment: IMG_5526.JPG
Description: IMG_5526.JPG

Attachment: IMG_5529.JPG
Description: IMG_5529.JPG