{Chrysler 300} Just A Heads Up

["william ELDER" <belder@xxxxxxxxx>]

I am replacing the dash pad on my 300G.  I read through the blog from Just Dashes to give me a leg up on this project.  I got to the rear view mirror removal, working through the speaker hole, even the radio is out.   I tried to get a 1 3/8 socket on the mirror nut.  Just dashes indicated that the nut was 1 3/8.  I just couldn’t get a socket on it, so I cut a perfectly fine 1 3/8 combination wrench in half, it was too long to fit inside the dash.   So after wasting a lot of time and effort, I finally realized the nut is 1 7/16.  Just in case any of you have to remove the rear view mirror.

 

Regards

bill

 

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/003501d93c00%24146043e0%243d20cba0%24%40cogeco.ca.