{Chrysler 300} Question on installing spring clips for nose letters on my 1959 300 E

[rob <rob@xxxxxxxxxx>]

Hello 300 Group

About three months ago after a nice Sunday drive I discovered my LETTER

“S” on the hood nose of my 300 had disappeared.  I suspect it just fell out.

I was able to find a replacement S from the Quigly company. It is 

not chromed…but it will do. Then I learned I needed a set of spring clips

to properly attach it.  I was able to get the spring clips…a set of 8! 

Now the challenge of how to properly install it? I tried putting it in the hole

and gently tapping the clip. This did not work adequately. Then I tried

attaching it first to the post of the letter and gently tapping that into

the hole. This resulted in the post on the letter bending. Any advice on how

to properly install my new letter.  I did think about using adhesive….

however the proximity to the radiator leads me to believe an adhesive will fail due to the heat.  

I will be grateful for some good advice?

Here’s a few photos….

Thanks.  

Rob

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/d240f85a-f0e6-467a-a58e-659aca6bb88bn%40googlegroups.com.