RE: {Chrysler 300} 64 upshift timing setting

Do you mean transmission rod adjustment?

From: Cox Mail <scooter465@xxxxxxx>
Sent: Sunday, November 21, 2021 5:07 PM
To: apozdol@xxxxxxxxxxx
Cc: Chrysler 300 Club International <chrysler-300-club-international@xxxxxxxxxxxxxxxx>
Subject: Re: {Chrysler 300} 64 upshift timing setting

If you make the transmission

Kick down rod longer it

Will shift later.

Make it shorter it will shift

Sooner. The lever on the transmission should be all

The way forward with the throttle closed on curb idle.

Bob Haag

On Nov 21, 2021, at 5:01 PM, apozdol@xxxxxxxxxxx wrote:

I could not find the recent thread in the archives regarding increasing the upshift timing on the 63-64 300’s. Will lengthening the carburetor rod raise the upshift timing? Or shortening?

I have done all of the prescribed adjustments described in the manual, twice. Getting the pedal to 114 degrees is now almost touching the floor board!

There isn’t a rubber stop internally on the throttle transmission lever in there that may have worn or deteriorated, is there?

My trans is not downshifting to my liking with more throttle. Stays in 2^nd when accelerating after upshift at a very slow roll, and then stays in 3^rd no matter what at speeds from 25 mph and up.

Or do it a third time?
--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/005501d7df23%2444f909a0%24ceeb1ce0%24%40comcast.net.