Pretty sure the holes and nuts are already there—the hole and nut plugged with a rubber plug. Just use the standard seat-belt bolt. May or may not be set up for three belts but seems OK to tether the center belt (if used) to the center bolts for the outside belts. That was the design for our ’64 300K convertible. Plugs and holes are readily visible with lower cushion out. May want to chase the threads before inserting the bolts. Rich B. Brentwood, CA (Thrashing at the leash) From: Chrysler300@xxxxxxxxxxxxxxx <Chrysler300@xxxxxxxxxxxxxxx> On Behalf Of Ronald Klinczar rjklinczar@xxxxxxxxx [Chrysler300] I would like to install seat belts in the back seat of my 300 and am also interested in this drilling concept. I am apprehensive that a drilled non threaded hole would provide support. Ron Klinczar 65 300 On Wed, Jul 1, 2020, 5:33 PM jackcboyle@xxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:
__._,_.___ Posted by: "Rich Barber" <c300@xxxxxxx> To send a message to this group, send an email to: Chrysler300@xxxxxxxxxxxxxxx To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or go to https://groups.yahoo.com/neo/groups/all/manage/edit For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang __,_._,___ |