Re: [Chrysler300] Rocker Moulding Removal
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] Rocker Moulding Removal





Sounds like the 59's. Been awhile, but I believe you push on the middle of the moulding which slightly expands the edges to escape the clips.

Sent from my BlackBerry 10 smartphone on the Rogers network.
From: 2HsandaHeritage@xxxxxxxxxxx [Chrysler300]
Sent: Friday, June 9, 2017 9:21 PM
To: scooter465@xxxxxxx
Reply To: 2HsandaHeritage@xxxxxxxxxxx
Cc: Chrysler300
Subject: Re: [Chrysler300] Rocker Moulding Removal

 

Scooter,
Thanks for the reply.
The 62 rocker mouldings are held on with clips that are screwed onto the rocker panels.
Only one visible screw is at the very front of the moulding.
What I don't know is if there is away to pry them off of the clips, or if I remove the screw, can I pull/ slide the moulding forward for removal
Doug



From: scooter465@xxxxxxx
To: 2HsandaHeritage@xxxxxxxxxxx
Cc: "Chrysler300" <Chrysler300@xxxxxxxxxxxxxxx>
Sent: Friday, June 9, 2017 7:00:50 PM
Subject: Re: [Chrysler300] Rocker Moulding Removal

Rocker panel moldings are held on with screws. If tight strike the screw with a hammer that will break them loose from rust. Not rocket science.

Sent from my iPhone

On Jun 9, 2017, at 9:49 PM, 2HsandaHeritage@xxxxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

 

Hi Group,
I need some expert advice on the correct procedure to remove the rocker mouldings on my 62 Sport Conv.
Doug Warrener






__._,_.___

Posted by: lindsey@xxxxxxxxxxxxxxx


To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang





__,_._,___


Home Back to the Home of the Forward Look Network Archive Sitemap