Re: [Chrysler300] Rocker Moulding Removal

["2HsandaHeritage@xxxxxxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx>]

Scooter,

Thanks for the reply.

The 62 rocker mouldings are held on with clips that are screwed onto the rocker panels.

Only one visible screw is at the very front of the moulding.

What I don't know is if there is away to pry them off of the clips, or if I remove the screw, can I pull/ slide the moulding forward for removal

Doug

---

From: scooter465@xxxxxxx
To: 2HsandaHeritage@xxxxxxxxxxx
Cc: "Chrysler300" <Chrysler300@xxxxxxxxxxxxxxx>
Sent: Friday, June 9, 2017 7:00:50 PM
Subject: Re: [Chrysler300] Rocker Moulding Removal

Rocker panel moldings are held on with screws. If tight strike the screw with a hammer that will break them loose from rust. Not rocket science.

Sent from my iPhone

On Jun 9, 2017, at 9:49 PM, 2HsandaHeritage@xxxxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

 

Hi Group,

I need some expert advice on the correct procedure to remove the rocker mouldings on my 62 Sport Conv.

Doug Warrener

__._,_.___

---

Posted by: 2HsandaHeritage@xxxxxxxxxxx

---

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang

Visit Your Group

• Privacy • Unsubscribe • Terms of Use

__,_._,___