Matt, That should be a fairly common part. Check with any hardware or electronics store that sells solderless connectors and kits. The bullet ends come in at least two different diameters as I recall, so bring the old one to match up. Or you could just try re-soldering the original connector back in place. Bob J _____ From: Chrysler300@xxxxxxxxxxxxxxx [mailto:Chrysler300@xxxxxxxxxxxxxxx] On Behalf Of Matt Allyn Sent: Tuesday, December 02, 2008 7:58 AM To: Chrysler300@xxxxxxxxxxxxxxx Subject: [Chrysler300] 1962 Parking Brake Switch Plug My parking brake light stopped working on our 1962 300, so naturally I replaced the bulb....which didn't solve it! I then looked at the switch and noticed the 46 year old wire had left it's housing. I have pulled off the small "bullet" looking connector. Anyone know if these connectors are still available? If not I will need to un-crimp the current bit of wire still inside the connector and crip a new stripped wire into it. Matt Allyn [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] ------------------------------------ To send a message to this group, send an email to: Chrysler300@xxxxxxxxxxxxxxx For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm For archives go to http://www.forwardlook.net/300-archive/Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Chrysler300/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/Chrysler300/join (Yahoo! ID required) <*> To change settings via email: mailto:Chrysler300-digest@xxxxxxxxxxxxxxx mailto:Chrysler300-fullfeatured@xxxxxxxxxxxxxxx <*> To unsubscribe from this group, send an email to: Chrysler300-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/