Tom My 65 300L has 7 leaves on each side. Don't know about a 4 speed. Ray San Jose Ca. ----- Original Message ----- From: Tom Denkler To: jblken@xxxxxxxxxxx ; Chrysler300@xxxxxxxxxxxxxxx ; lettercars@xxxxxxx Sent: Sunday, July 23, 2006 9:54 AM Subject: Re: [Chrysler300] 300H REAR SPRINGS QUESTION Anyone know how many leaves 65 300 L has? is 4 speed diffeerent? Thanks, Tom Denkler ----- Original Message ----- From: <lettercars@xxxxxxx> To: <jblken@xxxxxxxxxxx>; <Chrysler300@xxxxxxxxxxxxxxx> Sent: Sunday, July 23, 2006 7:45 AM Subject: Re: [Chrysler300] 300H REAR SPRINGS QUESTION > > Hi Ken and All: > I don't know if anyone answered your spring leaf question, but didn't see > it > on the listserver, at any rate. The 300H has six leaves, convert or > hardtop, rt. or left. The spring rate is 125 lbs/in (160 at the wheel). > Since > these specifications are the same as the Newport station wagon, I suspect > the > springs might be the same. > > On the rear seatbelt question both you and Fern had---I am not sure I can > be > of too much help, other than to say I have put anchors in both my "H" > convert > and "F" convert. The "H" was done so long ago (35 years or so) that I > don't > remember how I located them. I suspect so that I could route them under > the > plywood. On the 300F, much more recently, I found dimples in the floor > pan > that I assumed were for the purpose of seat belt anchor location, so > utilized > them. Since I haven't installed the actual rear seatbelts yet, I can't > say > how that will work out. Will have to be done pretty soon, though. On > your > 300Hs, I think I would try to find the dimples and use them. Hopefully, > by > 1962 some design work went into the prefered location of the rear > anchors. > Hope this helps a little. > 300ly, Gil Cunningham > Tallahassee, FL > (Hoping for a bit of rain today!) > > In a message dated 7/20/2006 1:39:39 AM Eastern Standard Time, > jblken@xxxxxxxxxxx writes: > > Help! - how many rear leafs is there in the 300H > convert (or hdt). is the right side suppose to have > more leafs then the left side? I assembled 7 leafs, > both sides, but the front clamp band, of one > reassembled spring (I took spring apart so many years > ago along with others that I do not remember the > assembly or if I got all the leaf count), was still > loose so I stuck a short 12" half leaf to fill the > band. I stuck this (now 8 leaf count) spring on the > right side. The other spring, in which the clamp band > was fully filled with just 7 leafs, - I installed on > the left side. Today I installed the freshly restored > rear axial but holding off tighten it untill I hear > some comments. > > Thanks in advance - Ken Wilson > > > > > > [Non-text portions of this message have been removed] > > > > > To send a message to this group, send an email to: > Chrysler300@xxxxxxxxxxxxxxx > > For list server instructions, go to > http://www.chrysler300club.com/yahoolist/inst.htm > > For archives go to http://www.forwardlook.net/300-archive/ > Yahoo! Groups Links > > > > > > > [Non-text portions of this message have been removed] ------------------------ Yahoo! Groups Sponsor --------------------~--> Something is new at Yahoo! Groups. Check out the enhanced email design. http://us.click.yahoo.com/SISQkA/gOaOAA/yQLSAA/8LmulB/TM --------------------------------------------------------------------~-> To send a message to this group, send an email to: Chrysler300@xxxxxxxxxxxxxxx For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm For archives go to http://www.forwardlook.net/300-archive/ Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Chrysler300/ <*> To unsubscribe from this group, send an email to: Chrysler300-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/