Re: [Chrysler300] 413 Cam Clearance

[Mike Apfelbeck <moparmike@xxxx>]

If the valve stem installed height is within specs and an excessive amount 
has not been milled from the heads or the block, the stock length pushrods 
will be fine. You should check the rocker arm to valve stem clearance to be 
sure.
Mike

At 08:43 PM 10/27/2003 -0800, jennifer allyn wrote:
> Working on our 1962 300, which has a 1964 413 under the hood. I'm wanting
> to know if anyone has had any clearance problems with the following specs
> under the hood:
>
>
>
> Valve Lift: Intake = .458", Exhaust = .470"
>
> Duration: Intake = 208 degrees, Exhaust = 214 degrees
>
> Timing Opening: Intake = 5 degrees ATC, Exhaust = 42 degrees BBC
>
> timing Closing: Intake = 33 degrees ABC, Exhaust = 8 degrees BTC
>
>
>
> Looking to use a stock length pushrod and just wondered if I may have any
> clearance issues...
>
>
>
> Thanks!
>
>
>
> Matt Allyn
> (323) 468-4619
>
>
>
>
>
> [Non-text portions of this message have been removed]
>
>
>
> To send a message to this group, send an email to:
> Chrysler300@xxxxxxxxxxxxxxx
>
> For list server instructions, go to 
> http://www.chrysler300club.com/yahoolist/inst.htm
>
> To unsubscribe from this group, send an email to:
> Chrysler300-unsubscribe@xxxxxxxxxxxxxxx
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/