Re: {Chrysler 300} 300F starter motor

I had mine rebuild local here in Nevada with a new armature and I think it was a little over 200 bucks us

Frank HInmon

661-809-7994

On Feb 19, 2025, at 12:47 PM, 'James Douglas' via Chrysler 300 Club International <chrysler-300-club-international@xxxxxxxxxxxxxxxx> wrote:

Can anyone advise on if they are using a Powermaster 9533 on a 1963 or 1964? I want to make sure that the 413 block is not different around the starter in some small way and the 9533 will work on it.

Thanks, James

From: chrysler-300-club-international@xxxxxxxxxxxxxxxx <chrysler-300-club-international@xxxxxxxxxxxxxxxx> On Behalf Of dplotkin@xxxxxxxxxxxxxxxxxxx
Sent: Wednesday, February 19, 2025 07:45
To: henry.schleimer@xxxxxxxxxxxxxxx
Cc: chrysler-300-club-international@xxxxxxxxxxxxxxxx
Subject: RE: {Chrysler 300} 300F starter motor

I have an aftermarket Powermaster on the 440 in my 61 Plymouth which has been obedient since 2007 with sometimes long crank cycles.

However I believe Australia has more than one auto-electric shop. Has to, the place is awash in alternators and starters like any other developed nation. The AutoLite starter is a simple device that any shop should be able to find or source the brushes and bushings likely needed to repair it. I'd fix one before I replaced it.

Dan

-----Original Message-----
From: henry.schleimer@xxxxxxxxxxxxxxx
Sent: Wednesday, February 19, 2025 10:21am
To: chrysler-300-club-international@xxxxxxxxxxxxxxxx
Subject: {Chrysler 300} 300F starter motor

I have an email from April Maxwell looking for advice about fixing her 300F starter that is going bad here in Australia. I don’t have experience with these so I am asking for some help. Apart from taking it to someone who could fix it (which might be hard to find these days) an aftermarket alternative is probably an easier option. I vaguely recall there may be problems fitting some of these. Here is a link to a local shop with a couple of types. https://www.hemiperformance.com.au/shop/shop-by-category/electrical/starter-motor.html

Are any of these ok to use? If not, any other brands that would work?

Thanks

Henry

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/004e01db82e1%24eb2da050%24c188e0f0%24%40optusnet.com.au.

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB6171D568D3D0DC907D993AA493C52%40CY5PR19MB6171.namprd19.prod.outlook.com.