Hi to all,
I have been messing around with my '58 300 D a little over the last few
days. The dash and steering column are completely out of the car. The
push button selector is just hanging by its wires and cable.
The problem is that the car had previously been in neutral, so I could
crank it, etc. Today I was playing with the selector, pushing the gear
selector buttons in and out to make sure the springs were working,
etc.. There is also a bar that goes over the top that also moves back and
forth and I was manipulating that as well. Anyway, later today I decided
to crank the car. Thank God the drive shaft has been disconnected at the
back end!! I could hear the transmission turning the shaft! I was sure
that I had put the selectors back as I had found them. Well, I tried the
selectors again, this time making sure I had pushed the neutral/start
button in and that it "caught" in the correct place, but the car is still
in gear. Is there something special I need to do to get the car back into
neutral? What am I doing wrong here? I have no real experience with
these push button selectors.
I have had the car in storage and just brought it home on Wednesday to
stay in my garage, so this is the first time I have really been able to
play with it. Thanks for all help in advance!!!
Dean Mullinax
[Non-text portions of this message have been removed]
To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx
For list server instructions, go to
http://www.chrysler300club.com/yahoolist/inst.htm
To unsubscribe from this group, send an email to:
Chrysler300-unsubscribe@xxxxxxxxxxxxxxx
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
Back to the Home of the Forward Look Network
Archive Sitemap