Re: [Chrysler300] Driveshaft Advice

[Lindsey Fuller <lfuller@xxxxxxx>]

jennifer allyn wrote:

>For the 1962 300..
>
> 
>
>I have replaced both the front and rear u-joints and have some vibration
>going on now, after a couple of hundred miles.
>
>I now will be ordering a front housing as that part must be a bit worn out.
>
>I cannot find anyone to balance the driveshaft in the Southern California
>area.  Anyone know of a place who can still balance one of these?
>
> 
>
>I am even considering changing the front joint to a more modern set up.  One
>place (PTO Sales in Fontana, CA) said they could do it, though did not have
>a proper piece to match up to the parking brake drum.  I can start calling
>other driveshaft shops, though wondered if anyone had any suggestions for
>me.
>
> 
>
>Thanks!
>
>Matt & Jennifer Allyn
>
>
>
>[Non-text portions of this message have been removed]
>
>
>
>To send a message to this group, send an email to:
>Chrysler300@xxxxxxxxxxxxxxx
>
>For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm 
>Yahoo! Groups Links
>
>
>
> 
>
>
>  
>
the cause of my driveshaft vibration was one of the yokes? where the 
rear u joint is, were fatigued. replaced same & no vibration.



To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
     http://groups.yahoo.com/group/Chrysler300/

<*> To unsubscribe from this group, send an email to:
     Chrysler300-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
     http://docs.yahoo.com/info/terms/