[Chrysler300] Digest Number 656

[<Chrysler300@xxxxxxxxxxxxxxx>]

------------------------ Yahoo! Groups Sponsor ---------------------~-->
Get A Free Psychic Reading! Your Online Answer To Life's Important
Questions.
http://us.click.yahoo.com/Lj3uPC/Me7FAA/ySSFAA/8LmulB/TM
---------------------------------------------------------------------~->

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to
http://www.chrysler300club.com/yahoolist/inst.htm 

To unsubscribe from this group, send an email to:
Chrysler300-unsubscribe@xxxxxxxxxxxxxxx


------------------------------------------------------------------------

There is 1 message in this issue.

Topics in this digest:

      1. Re: Lower rear quarter panels
           From: "patrick grant" <gran102@xxxxxxxxxxxxx>


________________________________________________________________________
________________________________________________________________________

Message: 1
   Date: Fri, 13 Jun 2003 09:16:36 -0400
   From: "patrick grant" <gran102@xxxxxxxxxxxxx>
Subject: Re: Lower rear quarter panels

this post prompts me to ask if these panels as being represented for 57-59
would not also work on 60-62's. i realize the 62 had a rear bumper indent
and the top edge of the replacement panel might require a lower cutoff
point but is the wheel well curvature and rocker panel ledge not the
same.? after all most car rot out at the bottom 6-8 inches and that is the
hardest to form if you dont have a replacement panel. also would these
panels not also fit desotos and dodges and plymouths.  that would increase
the volume for metalcrafters and maybe prompt more panels.??
  ----- Original Message ----- 
  From: George McKovich 
  To: Chrysler 300 Broadcast 
  Sent: Thursday, June 12, 2003 6:35 PM
  Subject: [Chrysler300] Lower rear quarter panels


  I am curious if anyone else has found the new quarter panels from
  MetalCrafters to be too short when doing the installation?? We found the
  bottom of the front edge of the panels to be 5/8" too short and the rear
  part to range from about 1/2" at the top to about 1-3/8" short at the
  bottom. Take a look at the following webpage and you can see what I am
  referring to:

  http://www.collectorsautoparts.com/quarters.htm

  The shortfall is between the blue and red lines in the first two
pictures.

  In any case, the passenger side is now on and ready for additional panel
  beating to bring it around to being straight.... And that makes me very
  pleased.

  George



  [Non-text portions of this message have been removed]


        Yahoo! Groups Sponsor 
       
       

  To send a message to this group, send an email to:
  Chrysler300@xxxxxxxxxxxxxxx

  For list server instructions, go to
http://www.chrysler300club.com/yahoolist/inst.htm 

  To unsubscribe from this group, send an email to:
  Chrysler300-unsubscribe@xxxxxxxxxxxxxxx



  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 


[Non-text portions of this message have been removed]



________________________________________________________________________
________________________________________________________________________



Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

<<attachment: winmail.dat>>