Sort of depends what was really done. Sometimes a light honing will
clean up a cylinder without materially enlarging the bore. On the
other hand, if there serious rust or pitting and that was honed out,
then the cylinder might need sleeving. I personally wouldn't be
afraid to use the cylinder if the bore was clean, round, straight and
only a few thousandths over standard. Anything more than .020" or so
I would consider suspect. I think you need the cylinder measured to
make a decision.
Bill Huff At 6/30/200911:58 AM, eastern sierra Adj Services wrote: On the Evilpay, now, is an overhauled single pot master cylinder. The seller confirms only that its orifice(s) has/have been "honed out". Shouldn't one, or both of the line connections to its cast iron body be SLEEVED or bushed with a steel insert, too, to prevent leakages? Neil Vedder ************************************************************* To unsubscribe or set your subscription options, please go to http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1 ************************************************************* To unsubscribe or set your subscription options, please go to http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
|