Hi
everyone,
I bought a set of
new rear axle outer seals (National 8704S) for my '58
Plymouth.
When installing
them, the seal lip is too high to touch the axle shaft, and a little bit too low
to touch the drum's hub when I put it on the axle shaft.
I no longer have the
old seal for comparison purposes, nor do I remember how it was
seated.
Am I missing
something ? Have I bought the correct seals (I took the reference out of this
page : http://www.autohobbydigest.com/8_75.html)
?
Thanks for your
help.
Vincent
Van Humbeeck '58
Plymouth Belvedere 2-door
hardtop ************************************************************* To unsubscribe or set your subscription options,
please go to |