hello everyone, thank you for all your help. yesterday morning i started
checking everything and nothing would work so i decided to pull out the dash,
fun job, when i went to take out the gauges the dome light went on, everything
worked, i decided to take the whole dash out anyway to see if i could find the
problem, the only thing that i could determine was the either the amp power wire
was a little loose or it was shorting out on the amp gauge, the studs on
the amp gauge are pretty long and the back of the gauge was covered in masking
tape from the factory, not a good insulation from all these years it was quite
brittle. this is the only place i can figure the problem was, i tested it by
taking off the wire and everything went dead as before. this was quite the
experience, i will test drive it today and hopefully i have it fixed, i will be
leading the Clydesdales this coming Saturday at the bad boys car show in St.
Cloud, MN so i do not need any problems. electrical problems are not my favorite
problem to fix. now to just put the dash back together and i'm hopefully ready
to go. thanks again for all your suggestions.
jim
*************************************************************
To unsubscribe or set your subscription options,
please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
|