Bryan - If you're talking about the sheet metal itself, cut out the offending section and bring it to a sheet metal fabricator, who can make the piece with the same bends, angles, etc. Then weld the new piece in. Ron ----- Original Message ----- From: "Bryan Scott" <scott1990@xxxxxxxxxxxxx> To: <L-FORWARDLOOK@xxxxxxxxxxxxx> Sent: Wednesday, April 20, 2005 10:03 PM Subject: [FWDLK] 57 or 58 sedan parts car-got one? > Hi all, > > I'm writing to see if anyone out there has a 57 or 58 parts car. Here's > what I'm looking for: The sill under my rear window (58 Fireflight sedan) > is rotted in each corner, running from the point where the sill meets the > roofline, about 14" along the sill, heading toward the middle of the sill. > I'm wondering if anyone with a parts car would be willing to cut out the > sill on each side and sell it to me? I bet you don't see this request every > day.... > > Thanks! > > ************************************************************* > > To unsubscribe or set your subscription options, please go to > http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1 ************************************************************* To unsubscribe or set your subscription options, please go to http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
|