Re: [FWDLK] Brake return springs
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [FWDLK] Brake return springs



In a message dated 12/17/2003 10:55:39 PM Eastern Standard Time, pontiac@xxxxxxxxxxxxxx writes:
get them on by hooking a screwdriver under the hook on the spring and
using it like a pry bar, pulling the hook past where it has to go - as long
as you pivot close to or at the same point as the post, when you pull past
it the spring slides down the screwdriver and usually I can get it right on
where it belongs in a couple tries, it just pops into place.
Buy the brake Pliers.  They are called pliers, but like nothing you have ever seen.  In addition to having all the leverage you need, they have appropriate hooks to SAFELY hold the springs while a point digs into the brake lining to pull them into place when removing them.  When putting the springs back over the posts, there is a cupped end to safely fit over the posts without slipping off, which is a danger when using a screwdriver.
 
Joe Savard
Lake Orion, MI USA



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.