Hello everyone, Since Jason's brakes failed, and even though I have already replaced the two front brake hoses and intend to replace ther rear and the master cylinder hose, I have been seriously considering changing the sytem to a dual system (or whatever you call it). If I understand correctly, all I need to do is replace the master cylinder with a dual model, run a separate line to the rear to isolate the rear from the front. I'm handy enough to run a new brake line (familiar with tubing benders, cutters, flaring tools, etc) so I don't think this will be much of a problem Here's what I don't know: Is there "special" master cylinder I need to get? (my mechanic says it has to match properly with the system or you can get too much or too little pressure) Where do I get the new cylinder? Are there any other considerations I didn't menion above? What else do I not know about this project? While I'm at it, any help on locating new shoes and wheel cylinders would be appreciated also. Thanks Joe and Jason 56 Belvedere (rearend still noisy as h..l) __________________________________________________ Do You Yahoo!? Find a job, post your resume. http://careers.yahoo.com
|