Can someone with a flat head 6 take a look at their distributor and tell me any of the following . a) which way the id plate is facing. Towards the top of the motor or bottom of motor. b) which way is the vacuum advance pointing. c) the adjustment screw to allow you to turn the distib. The one attatched to the distrib (not the block) Is it on top or bottom. There's two ways to attach the bracket to the distrib. if I attach it the way it has been attached (but looks wrong from the one pic in the shop manual) I can't get the power steering pump to clear the clips on the distributor. If I attach it the other way, it brings the adjustment screw to the top and put the clips in an ok positon I believe, but I can't sink the distributor in far enough beacuse the adjustment bolt hits the block. I do have the correct distrib, I checked the numbers. Can anyone shed any light on this Thanks, Nick |