Nick, In addition to the general solutions provided by Dave bellow, I have the "Installation Instructions" for adding a radio to a non radio equiped car (1956 Dodge). Radio interference elimination is performed by adding condensers to 3 locations: 1. Condenser lead wire to generator terminal A, armature. Condenser body mounted to generator case ground screw. P/N 1V580837. 2. Condenser lead wire to ignition coil primary terminal (+ terminal). Condenser body mounted to coil mounting bracket. P/N 8B520675. 3. Condenser lead wire to voltage regulator battery terminal (BAT). Condenser body mounted to the regulator mounting bolt. P/N 1A537604. These P/N are the "radio manufacturer's P/N". MOPAR translations I do not have. Used parts in good condition should be safe to use. Radio Shack may be able to suggest a functional equivalent. Dave Homstad 56 Dodge D500 ------------------------------------------------------------------------------ At 03:53 PM 9/14/98 -0400, you wrote: >Sperduto, Nick wrote: > >> Anyone got a good remedy for getting rid of igniton noise in my radio. >> I fianlly installed speakers and radio in my car and the noise is pretty >> annoying. >> It happens regardless of tape radio. > >For anyone who is experiencing these problems, bear in mind there are 2 >types of radio interference. > >The first is actual "radio" interference; interference with the radio >waves. There are a few ways to reduce this: > >1) Use resistor spark plugs >2) Use resistor spark plug wires >3) Use a "tweener" interference remover (small adapter that fits between >coil and coil wire) >4) Relocate your antenna away from the engine compartment. > >The other type is an electrical interference. This type of interference >bothers the radio through the electrical wire, rather than through the radio >signal itself. This is often caused by turn signals, the generator, the >fan, or even the ignition points. It's caused by little 'jumps' in the >voltage in the electircal system. Radio Shack sells little "line >conditioners" or "electrical interference filters" that help the voltage >stay at a constant level with no variances. There are also generator >condensors, voltage regulator condensors and the like that will help remove >interference of this type. > >-Dave > > Dave |