[FWDLK] Oil Pump Shaft Stuck UPDATE

[Ron Waters <ronbo97@xxxxxxxxxxx>]

OK, the shaft is out.

The block was mounted on an engine stand. I rotated the block 180 degrees so
that it was upside down, then I drove the shaft out with a screwdriver. It
came out with a T-shaped copper bushing attached. The bushing is 1" wide by
1.25 " tall. This is what the shaft was stuck on.

Initially, the bushing was stuck on the shaft. But I managed to remove it
without damage. Is this bushing easily available ? Should I reuse it, or get
a new one ?

Thanks,

Ron

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1