[FWDLK] 413 rebuild

[ajl <alacaria@xxxxxxxxxxx>]

> Hi all;


I am working on a 61 413 engine with 60,000 miles. It had a smoking 
problem, but no leaks from the front or rear seals, actually no leaks at 
all in any.

The engine is on a stand, heads etc.. pulled. I documented and removed the 
pistons and rods yesterday.

The rod bearings look very good.

Checked the bores and tolerances, looked good, honed the bores and this is 
where I stopped.

I purchased rings, main and rod bearings from NAPA


Question, would you replace the rods and main bearings along with the front 
and rear seals?


Anthony

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1