My 1955-58 Chrysler parts manual shows the outside front and rear door handles on '55 Chryslers, Imperials and DeSotos are the same on each side, but each side is different. Ditto for 1956. The internal latch hardware would be different due to a varying width of the doors and the front doors only locking. I would appreciate and respect anyone's observations to the contrary. A helpful consultant recently suggested the back door handles might be a better choice as they would have been used less. As a matter of possible interest, I have noted that the part number for the longer front window crank of a Chrysler or Imperial is 1602528 and the shorter rear quarter window crank is 1602529. This varies somewhat from the numbers in the parts book at Codes 23-14-18 and 23-14-79. The shorter rear window crank allows operation without banging one's knuckles on the rear arm rest. Rich Barber Brentwood, CA 1955 C-300 (Looking for very nice outside door handles for both sides) -----Original Message----- Date: Sun, 15 Oct 2006 09:32:26 -0500 From: Terry & Andree Hoeman <tehoema@xxxxxxxxxxxxxx> Subject: Re: 55 2 door new yorker I should have lots of 4 door latches available if needed. Still have 3 = parts cars sitting here for a while. ----- Original Message -----=20 From: LeRoy R. Thompson=20 To: L-FORWARDLOOK@xxxxxxxxxxxxx=20 Sent: Saturday, October 14, 2006 9:31 PM Subject: Re: [FWDLK] 55 2 door new yorker Hello, The four door front latch will work on the two door car but the rear = latch is different from the front. At least it was on the 56 DeSoto. regards, LeRoy ************************************************************* To unsubscribe or set your subscription options, please go to http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1 |