----- Original Message -----
Sent: Monday, August 28, 2006 7:07
AM
Subject: Re: [FWDLK] Crankshaft pulley
puller??
Not sure what engine you're working on but a 325 poly does not have
a harmonic balancer. No holes in the balancer to pull wth. I just pulled the
crank pulley on mine using something similar to what you showed on ebay,
just bigger. A rental will work fine.
Jim
Detroit
--------------
Original message --------------
From: Ray Jones <hurst300@xxxxxxxxxxxx>
> THIS ITEM IS NOT WHAT YOU NEED. It's for pulling gears on
shafts and
> grabs the gear at the outer edge. If you did that to a
Crankshaft
> Pulley, you could pull off/move the Harmonic Balancer.
The balancer is
> attached with a rubber mount and cam be pulled
loose.
>
> You need a plate type puller that uses bolts thru
slotted legs of a
> plate. Bolts go thru the slots into threaded
holes on the pulley
> center and then you apply pressure by turning
the center big bolt
> against the crank. Available at most parts
stores for $15 or so.
>
> Ray
>
>
> On
Aug 27, 2006, at 8:52 PM, debenson2 wrote:
>
> >
>
> Crankshaft pulley puller??
> > I need to pull a crank! shaft
p ulley on an early poly V8, will this part
> > work eBay item #
110025713377??
> > Anyone have name for the part I need and place
to buy one?
> > Thanks
> > debenson2
> >
> > *************************************************************
> >
> > To unsubscribe or set your subscription options,
please go to
> >
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
>
> *************************************************************
>
> To unsubscribe or set your subscription options, please go
to
> http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
*************************************************************
To unsubscribe or set your subscription options,
please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
Back to the Home of the Forward Look Network