Try NAPA for a choke heat tube repair kit. If they still have them
you get the tube and an insulating cover.
----- Original Message -----
Sent: Tuesday, January 10, 2006 12:59
PM
Subject: Re: [FWDLK] Tube that feeds heat
to choke control
Can
someone tell me if the tube pushes into the manifold of there is a nipple
pipe that goes between the manifold and the tube and the manifold.
This pipe appears to be made of steel. Is this a process of finding
this type of tubing and then bending it to match what I have
now?
The choke heat tube goes from the choke housing down and slips
into ANOTHER SEPARATE tube that goes completely through the exhaust
manifold. This second tube is pressed into the exhaust manifold, and has
a "step" in it to keep it in place.
This second tube is directly in the exhaust flame and is notorious for
burning through and allowing carbon to be sucked directly into the choke
system. The correct fix is to first check the tube through the exhaust
manifold to see if it is burnt through. If so, it must be replaced along
with the tube that you can see.
"In the day", the most common fix was to just install a manual choke
cable, and forget it! I, personally, just backed the choke out of the
way and learned to give it a couple of pumps to start, along with a little
coaxing to keep it going until it warmed up a little. It's easier than
it sounds, and they get drivable pretty quickly!
That, by the way, is the reason that sinking the choke coil into the
intake manifold was such a positive change.
Joe
Savard
Lake Orion, Michigan
*************************************************************
To unsubscribe or set your subscription options,
please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
Back to the Home of the Forward Look Network