In a message dated 7/23/2005 12:28:06 A.M. Eastern Standard Time,
ronbo97@xxxxxxxxxxx writes:
In the
past, when I've done non-FL master cylinders, the advice was to
'bench
bleed' the master before installation, to remove air bubbles.
I assume that you mean to fill the cylinder before connecting the lines to
it. I see no reason not to, except that it may be a little messy.
There's no reason to pump a lot of air down through the lines when it could be
fluid.
Joe
Savard
Lake Orion, Michigan
*************************************************************
To unsubscribe or set your subscription options,
please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
|
Back to the Home of the Forward Look Network